Klarstein ENERGIEWENDE Bedienungsanleitung Seite 47

Note: Never use wet or moist pellets.
• Only use high-quality pellets (according to pellet standard DIN 51731 or
ÖNorm M 7135). Pellet diameter: 6 mm, length: ≤ 25 mm.
• While using the device for the fi rst time, try different brand pellets.
Choose a brand with a high calorifi c value but a low ash content and low
coking. Pellets with a high ash content increase the cleaning intervals. Too
many pellets block the screw conveyor, which stops the heating.
• The product is neither suitable for burning wood nor does it serve as an
incinerator.
• It is strictly forbidden to throw waste, garbage and plastics into the
heating system for incineration. This is illegal.
• Improper operation contrary to instructions can damage electrical
components (e.g. fans, screw motor, control unit) and shorten their service
life.
Instructions for Refi lling Wood Pellets
• Keep pellet plastic bags away from heating during pellet feeding.
• Do not overfi ll the funnel with pellets. Remove excess pellets to avoid
accidents.
• To prevent fi res, store the pellets in a heat-resistant container.
• If you see the screw at the bottom of the funnel, new pellets can be refi lled.
• Check the fi lling quantity of the pellets regularly.
• The hopper cover must always be closed, except when refi lling pellets.
CAUTION
Risk of burns! To avoid burns at high temperatures, always wear
protective gloves when opening the funnel cover.
EN
47