Auto-Hover; Flight Control - Modster FOLD 4K Betriebsanleitung

Manual

8. Auto-Hover

Start your first flight:
Push both control levers to the positions shown in the picture and hold
them for a few seconds. The lights on the drone will start to flash. The
motor starts working.
Auto-Hover:
After pushing the „take-off/landing" button, the drone will automatically
go up in the air and stay at a height of around 1.5 metres. After this step,
push the left stick to keep the drone at any height you want.
Press the „take-off/land" button again. Then the drone will slowly land
and finally the motor stops spinning.
Emergency Button:
In case the drone crashes against the wall or hits a tree, you can press the
„stop" button (2) . At the same time, the motor will stop spinning. Make
sure there are no people below the flying drone.

9. Flight Control

Please us the controller to practice simulated flights before the drone takes off the first time.
Place the drone on a flat surface, making sure that the yellow LED lights are facing away from you.
When you move the UP/DOWN lever up and the drone goes up, do this slowly. You should acquire a specific
kind of sensivity in regard to the use of the drone. When you move the lever down, the drown will also go
down.
When you move the TURN LEFT/TURN RIGHT lever into the left direction, the drone will move left. When
you move the lever right, the drone will also move right.
When you mobe the FORWARD/BACKWARD lever up, the drone will start to fly forward. Please do this
slowly to acquire a kind of sensivity in regard to the drone. When you move the lever down, the drone will
move backwards.
When you move the BANK LEFT/BANK RIGHT lever into the left direction, the drone will start to bank left.
Pleasy to this slowly to acquire a kind of sensivity in regard to to the drone. When you push the lever into
the right direction, the drone will also bank right.
22
MODSTER FOLD 4K
www.modster.at