Match The Frequency; Auto Tim Function - Modster FOLD 4K Betriebsanleitung

Manual
The throttle stick to lowest point.
Step 2: Press down the controller power
switch to turn on the power. The controller
will make one short beep sound and the
red LED will flash. To pair the si-gnals of the
vision drone and the controller, you must
RAISE the UP/DOWN lever on the controller
all the way to the top. And then LOWER it
to the bottom. It will make one short beep
sound. The next time you RAISE the UP/
DOWN lever the drone will lift into the air.
When flying outdoors, press the ,,Speed button" three times to set
the third speed.
1. Adjust the frequency.
2. Calibration
3. Start your flight.

6. Match the Frequency

Turn on the drone and remote control after the drone LED light blink
quickly. Push the left stick of the remote control to the highest point
and then pull to the lowest point. After the remote control send a „beep"
sound the frequency matching is finished and the drone LED light
becomes steady.
7. Auto Trim Function
Push both controler sticks to the position as shown on the picture and
hold them for a few seconds. The lights on the drone will start to flash.
Now the drone is recoverd to its original factory settings and ready to fly
again.
www.modster.at
Step 3: Always turn off the
power switch of the drone
after flight
Step 4: Always turn the
controller off after flight
and remove all the batteries
if you leave it unused for a
long period of time.
MODSTER FOLD 4K
Power Switch
Step 5: Please remove the bat-
tery by pres-sing down the tap
on the battery and extract the
battery. The first attempts could
be more sluggish then the next
ones.
21