Network Settings; Detection Sensitivity - STEINEL HPD2 IP Bedienungsanleitung

4.1

Network settings

This is where all settings can be made for the network interface.
You can use a static configuration or configure the network automatically via DHCP.
A dedicated SSL certificate can be uploaded for encrypted communication via SSL.
4.2 MQTT
Activate MQTT and enter all requisite communication parameters if you wish to use MQTT.
4.3 BACnet
Activate the BACnet interface if you wish to use it.
The sensor in the BACnet system can be addressed via the BACnet ID.
• Give each user an ID that is unique in the network.
For further information on the BACnet interface, please refer to the PICS document which you will find on our website.
4.4 Sensor settings
4.1

Detection sensitivity

The detection sensitivity can be adjusted in a range from 0 to 100. It is used as a threshold value for recognition of persons.
The factory settings is 35. The detection sensitivity must be adjusted if miscounts occur.
50/60Hz anti-flicker
• Adjust the mains adapter to the standard mains frequency in your country (an incorrectly adjusted frequency will cause
problems when detecting persons due to the flickering of the lamp).
Celsius/Fahrenheit
• Select the unit for the temperature.
Image brightness during the day
Adjustment of image brightness for daytime operation.
The light value has a range from 0 to 255.
Image brightness at night
Adjustment of image brightness for night time operation.
The light value has a range from 0 to 255.
Gamma value
Increases or decreases amplification of the dark and light pixels of the image. Values below 0 increase the contrast.
The gamma value and light value settings must only be changed if there are problems with contrast or brightness.
– 13 –