HANSGROHE ShowerSelect 15762003 Gebrauchsanleitung, Montageanleitung Seite 4

Spare parts (see page 18)
Cleaning
see enclosed brochure
Fault
Insufficient water
Crossflow, hot water being forced
into cold water pipe, or vice versa,
when mixer is closed
Spout temperature does not cor-
respond with temperature set
Temperature regulation not possible
Safety stop button not operating
Valve stiff
Shower or spout dripping
Pushbutton cannot be actuated or is
without function
Pushbutton is jammed or stiff
Pushbutton does not snap in
English
Cause
- Supply pressure inadequate
- Regulator filter dirty
- Shower filter seal dirty
- Backflow preventers dirty or leaking - Clean backflow preventers, ex-
- Thermostat has not been adjusted
- Hot water temperature too low
- thermo cartridge calcified
- For new installations: basic body
incorrectly connected (should be:
cold right, hot left) or installed with
180º rotation
- Spring defective
- Button calcified
- Select stop valve DN9 damaged
- Select stop valve DN9 damaged
- Safety guard of isolating valve has
not been removed
- Seal needs greasing
- Select Adapter incorrectly trimmed
Assembly see page 7
Remedy
- Check water pressure (If a pump
has been installed check to see if
the pump is working).
- Clean filter in front of the mixer and
on the MTC-thermo cartridge
- Clean filter seal between shower
and hose
change if necessary
- Adjust thermostat
- Increase hot water temperature to
42 ºC to 65 ºC
- Exchange thermo cartridge
- Install function block turned through
180º
- Clean spring and/or button, ex-
change if necessary
- Exchange Select stop valve DN9
- Exchange Select stop valve DN9
- Remove safety guard from isolating
valve
- Grease the seal
- Trim and mount Select Adapter ac-
cording to Fig. 8 (see page 8)
- First, fully press the pushbutton
down into the rosette; then, mount
the rosette
3