Lacor 61700 Gebrauchs- Und Instandhaltungsanleitung Seite 41

Change of weighing parameters
1.- To enter the change of specifications carry out the following procedure:
2.- Keep the CHANGE key pressed down and turn the weighing machine on at the same time.
Don't take your finger off of the CHANGE key until it shows 6.3
3.- Press the TARE/ZERO key and keep pressing it until the display shows SETUP.
4.- Press the 3 key, press the 1 key. The weighing machine will show the internal parameters
6XXXXX.
5.- Press the · key and keep it pressed for at least 5 seconds.
6.- Press the CHANGE key the display will show SEtUP.
7.- Press the 2 key the display will show SPEC.
8.- Press the CE key. The display will show 1. By successively pressing the CE key, you will go
from parameter 1 to 8.
These parameters have been defined by the weighing machine manufacturer, but
should they need to be changed, follow the following steps.
Parameter 1. Weighing machine resolution (A value to be indicated 075.00)
Press the · key. The weighing machine will show the current parameter.
Using the CE key to change the value and the · key to advance, it should indicate the value
075.00
Press the CHANGE key to accept the indicated value. It will indicate GOOD
Parameter 2. Sensitivity of the weighing machine (Value to be indicated 000.02)
Press the · key. The weighing machine will show the current parameter.
Using the CE key to change the value and the · key to advance, it should indicate the value
000.02
Press the CHANGE key to accept the indicated value. It will indicate GOOD
Parameter 3. Number of decimals in the weighing function (Value to be indicated 000.00)
Press the · key. The weighing machine will show the current parameter.
Using the CE key to change the value and the · key to advance, it should indicate the value
000.00
Press the CHANGE key to accept the indicated value. It will indicate GOOD
Parameter 4. Resolution of the weighing machine for use in Pounds (Value to be indicated 6614
Press the · key. The weighing machine will show the current parameter.
Using the CE key to change the value and the · key to advance, it should indicate the value
066.14
Press the CHANGE key to accept the indicated value. It will indicate GOOD
Parameter 5. Sensitivity of the weighing machine for use in Pounds (Value to be indicated 000.05)
Press the · key. The weighing machine will show the current parameter.
Using the CE key to change the value and the · key to advance, it should indicate the value
000.05
Press the CHANGE key to accept the indicated value. It will indicate GOOD
41