Lacor 61700 Gebrauchs- Und Instandhaltungsanleitung Seite 39

Instructions for weighing machine calibration
1.- Keep the CHANGE key pressed down and turn the weighing machine on at the same time.
Don't take your finger off of the CHANGE key until it shows 6.3 for weight and 5 for unit
price.
2.- Press the TARE/ZERO key and keep pressing it until the display shows SEtUP
3.- Press the TARE/ZERO key to enter the calibration mode. The display shows CAL-1 and
then 00.000
4.- Now you need a reference article (as heavier the object, the better the calibration) of which
you already know the correct weight. BUT DON'T PUT IT ON THE WEIGHING MACHINE
YET. Using the · and CE keys, the weight of the of the reference object should be shown in
the WEIGHT display. For this, use the · key to advance in the various positions and the CE
key to indicate the value (each time that you press the CE key, it will show 1,2,3,4,5,6,7,8
and 9), until the weight of your reference article is indicated, example, 005.80.
5.- Press the CHANGE key, being sure that there is nothing on the weighing machine. Wait for
the weight display to show 00000, and the unit price display indicates the internal values
6.- Place the reference article on the weighing machine. The weighing machine will show some
internal values.
7.- Wait until the value indicated in weight is stable. Then, press the CHANGE key. Wait until
the scale shows GOOD two times. Remove the reference article and the weighing machine
will automatically restart. End of calibration
8.- If upon turning on the weighing machine there is any kind of box or weight on the weighing
machine, this will take the weight of said article as the tare, showing 0.00 on the display.
To return to placing the weight at zero, remove any article from the weighing machine and press
the TARE/ZERO key
Instructions defining 2 decimals in UNIT PRICE and PRICE TO PAY
1.- Keep the CHANGE key pressed down and turn the weighing machine on at the same time.
Don't take your finger off of the CHANGE key until it shows 6.3.
2.- Press the TARE/ZERO key and keep pressing it until the display shows SEtUP.
3.- Press the 3 key the display shows USUAL.
4.- Press the 1 key the display will show internal values 6xxxxx.
5.- Press the · key and keep it pressed for at least 10 seconds.
6.- Press the CHANGE key. The display will show SETUP.
7.- Press the · key and keep pressing it until the UNIT PRICE display shows 3C5A.
8.- Press the CE key
9.- Use the · key to enter in 9 status. The WEIGHT display will show a value 00xxx.
10.- Use the · key to go forward, and the CE key to establish the value, until obtaining the 02xxx
value to advance in the various positions and the CE key to indicate the value (each time
that you press the CE key, it will indicate 1,2,3,4,5,6,7,8 and 9), until the reference value is
indicated.
11.- Press the CHANGE key once. The WEIGHT display will indicate good 2 times.
39