Installation Instructions - Blaupunkt BLUEBOT XVAC BPK-VCBB1XVB Bedienungsanleitung

INSTALLATION INSTRUCTIONS

1. Connect the power line and feed the excess wire
into the slot
2. Place charging station against the wall and connect
the power
>0.5m
>1.5m
• Direct sunlight will interfere with the charging signal and consequently, the robot may be unable to return to the
charging station.
• Ensure a space of more than 0. 5m on both sides of the charging station and a space above it of 1. 5m in the front
• If the power line is vertical to the ground, it may be dragged by the robot and consequently the charging station
may power off
• The charging indicator is normally on when powered on and off when charged
3. Please do not arbitrarily move the
out of direct sunlight
4. Installation of the side brushes
Make the left-side brush (L) and the right-side brush (R) correspond
>0.5m
to L and R on the bottom casing, press L and R and the side brushes
are installed when you hear a "cracking" sound
20
charging station
>0.5m
>0.5m
>1.5m
EN
and keep it