Technical Specifications - AEG LAVATHERM 59850 Benutzerinformation

Setting
Emptying water res-
ervoir - warning
2)
off
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the
water compared to those prefixed by the factory could slightly influence the residual humidity of the
laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based
on conductivity values of the water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water
reservoir is full. When using an external drain for the condensed water warning can be offi

TECHNICAL SPECIFICATIONS

Height x width x depth
Drum volume
Depth with loading door open
Height can be adjusted by
Weight when empty
Loading volume (depends on programme)
Voltage
Necessary fuse
Total power
Energy efficiency class
Energy consumption (7 kg of cotton, pre-
drained at 1000 rpm)
Average annual energy consumption
Use
Permitted ambient temperature
The consumption values have been established under standard conditions. They can deviate
1. Turn the programme selector to any programme.
2. Press simultaneously the SPIN SPEED (T/MIN) and TIME (TIJD
PROGR.) buttons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning
– warning
2)
Consumption values
when the appliance is operated in domestic circumstances.
Programme
Technical specifications
Implementation
icon and - warning message is off
icon and - warning message is switched on
85 x 60 x 58 cm
108 l
109 cm
1.5 cm
approx. 56 kg
1)
max. 7 kg
230 V
6 A
1050 W
A
1.9 kWh
126.2 kWh
Domestic
+ 5°C to + 35°C
applianceaverage drying time in min.
101