Inhaltsverzeichnis
Werbung
SCHEMATIC, CIRCUIT BOARD AND BLOCK DIAGRAMS
1 SCHEMATIC DIAGRAMS / CBA'S AND TEST POINTS
Standard Notes
WARNING
Many electrical and mechanical parts in this chassis
have special characteristics. These characteristics
often pass unnoticed and the protection afforded by
them cannot necessarily be obtained by using replace-
ment components rated for higher voltage, wattage,
etc. Replacement parts that have these special safety
characteristics are identified in this manual and its
supplements; electrical components having such fea-
tures are identified by the mark " ! " in the schematic
diagram and the parts list. Before replacing any of
these components, read the parts list in this manual
carefully. The use of substitute replacement parts that
do not have the same safety characteristics as speci-
fied in the parts list may create shock, fire, or other
hazards.
Capacitor Temperature Markings
Capacity
Mark
change rate
temperature
±
(B)
10%
(F)
+30 - 80%
±
(SR)
15%
(Z)
+30 - 80%
Capacitors and transistors are represented by the following symbols.
CBA Symbols
(Top View) (Bottom View)
+
(Bottom View)
Transistor or Digital Transistor
E
C
B
(Top View)
NPN Transistor
E C B
(Top View)
NPN Digital Transistor
E C B
Standard
Temperature
range
20°C
-25~+85°C
20°C
-25~+85°C
20°C
-25~+85°C
20°C
-10~+70°C
Electrolytic Capacitor
(Top View)
E C B
(Top View)
E C B
Notes:
1. Do not use the part number shown on these draw-
ings for ordering. The correct part number is shown
in the parts list, and may be slightly different or
amended since these drawings were prepared.
2. All resistance values are indicated in ohms
3
6
(K=10
, M=10
).
3. Resistor wattages are 1/4W or 1/6W unless other-
wise specified.
4. All capacitance values are indicated in µF
-6
µF).
(P=10
5. All voltages are DC voltages unless otherwise
specified.
6. Electrical parts such as capacitors, connectors,
diodes, IC's, transistors, resistors, switches, and
fuses are identified by four digits. The first two dig-
its are not shown for each component. In each
block of the diagram, there is a note such as shown
below to indicate these abbreviated two digits.
Schematic Diagram Symbols
PNP Transistor
PNP Digital
Transistor
Digital Transistor
1
Werbung
Inhaltsverzeichnis
