Nimco ZP 8000 Gebrauchsanleitung Seite 24

EN
Follow the instructions for assembly.
Do not install in the zones 0+1+2
Side view - basin
1. Firstly, prepare the final position of the mirror. The optimal way for choosing the right position is to place the mirror on the
required place on the wall and see if that suits you.
2. With help of the other person mark the upper edge of aluminium frame on the wall. Do not mark the edge of the mirror!
(Aluminium frame of some mirror models is of a different size than glass of the mirror!). Draw a small horizontal line. See the picture
below.
3. 60 mm under the line draw another line and using the water-level draw this line in a size of the mirror width. Doing this you
measured the height of the holes for screws (their horizontal position).
Mark the centre which you can measure by the sink or tap.
4. Now it is important to know the screw pitch, their vertical position. (NIMCO offers a wide range of models and types of
mirrors of different size. This general manual does not indicate the pitch for each model. It is then important to measure it.) The
pitch is measured directly on the mirror. On the back side of the mirror there are holes in the aluminium frame for vertical or horizon-
tal attachment. (Warning! It is possible to attach the mirror horizontally or vertically.). Choose the correct holes according to your
choice. These are the round holes. Measure their pitch, the distance of their centre lines (x).
24
navod-bez-7.2.indd 24 navod-bez-7.2.indd 24
7. Instructions for assembly
ZP 8000 - ZP 59999
ZP 8000V - ZP 59999V
Zone 1
min 40cm
above the upper edge
of the basin
Zone 0
Side view - bath
glass
aluminium
frame
Zone 2
26.08.2021 14:14 26.08.2021 14:14