General Information, Purpose Of Use; Safety Instructions; Handling; Installation - Nimco ZP 8000 Gebrauchsanleitung

Before the first use, the consumer is obliged to read the instructions to ensure secure and problem-free use of the product. It is
a stationary LED light determined to illuminate inner spaces like for example bathrooms, hallways, etc. The light is constructed as
a mirror with a light source located behind the mirror. The mirror can be used as a decorative lighting. Some models with larger
amount of individual LED diodes provide sufficient lighting and they can be used for illuminating the room. NIMCO LED mirrors are
illuminated by high-performance LED strips characterized by low energy consumption and clear luminosity. Lifespan of LED diodes
is up to 50.000 hours.
For any kind of handling, maintenance or assembly it is necessary to follow basic safety requirements resulting from the specific
activity. Please follow the next safety instructions in this manual.
Instructions marked by this sign are determined to prevent any risk or injury by general danger.
Instructions marked by this sign are determined to prevent any risk or injury by electric current.
Connecting to electricity network requires qualified electrician.
Requirements for connecting the bathroom mirror:
- The mirror shall be located according to valid security regulations.
- The mirror shall be connected to the mains in the network 1NPE 230V 50Hz TN-S.
- Front fuse max: 10A and residual-current device (RCD) 30mA
The light is packed in cardboard and covered by wrap and protected by polystyrene layer and MDF desk. Due to its weight and
large sizes, handling with the light should be done carefully. The light is equipped with mirror which is very fragile and easily bre-
akable. In case of handling with angular mirrors, let the protective plastic edges remain attached to the mirror and take them off after
the installation is done.
The light is determined to be attached to wall or another suitable inner surface.
The light can be installed in the area around the basin or around the shower or bath but it cannot be placed in zones 0+1+2 (see
the pictures in the paragraph Instructions for Assembly – installation on wall). Connecting to electricity network requires a qualified
electrician and must be done according to the regulation 50 Sb/78. Connect the supply cable (at the back side of the mirror) to
the existing mains in the wiring box placed preferably behind the mirror. If there is already a supply cable in the wall, it is possible
to connect it with the mirror cable on the back side of the mirror by the terminal box (article number ZP 01 – not included in the
package). It is highly recommended that the installation is accomplished by two persons.
navod-bez-7.2.indd 21 navod-bez-7.2.indd 21

1. General Information, Purpose of Use

2. Safety Instructions

3. Handling

4. Installation

EN
21
26.08.2021 14:14 26.08.2021 14:14