Slide In The Wind Protection Insert - Inventer Wse R-D200 Montage- Und Bedienungsanleitung

EN
3.2

Slide in the wind protection insert

Requirements: The inner cover's panel has been removed.
1. Slide the wind protection insert into the wall sleeve as far as the stop tape
(iV-Twin: 1 x wind protection insert per wall
Make sure that the slant is oriented downwards.
Make sure that the handle (green arrow) is pointing towards the interior.
3.3 Install the thermal accumulator insert and inner cover
Requirements: The wind protection insert is inserted.
1
4
1. From the building's interior, push the thermal accumulator insert as far as the wind protection insert.
Make sure that the green handle is pointing towards the interior.
Make sure that the protective grid is facing towards the interior.
2. Connect the controller.
3. Install the inner cover's base plate.
4. Place the fi lter back into the inner cover's base plate.
5. Attach the inner cover's panel.
16 Wind protection insert WSE
All manuals and user guides at all-guides.com
sleeve).
2
Make sure that the markings on the plug and socket are aligned.
• Installation and operating instructions
3
1
5
2