Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Looking for blockages
•
Switch 'OFF' and unplug before looking for blockages. Failure to do
so could result in personal injury.
•
Leave to cool down for 1-2 hours before looking for blockages.
•
Beware of sharp objects when checking for blockages.
•
Make sure any blockages are clear and all parts are refitted before
using your machine.
•
Refit all parts securely before using.
•
Please refer to 'Looking for blockages' illustrations or 'Online support'
section for additional guidance.
•
To gain access to blockages behind the brush bar, remove the base
plate by using a coin to loosen the fastener marked with a padlock.
•
Clearing blockages is not covered by your guarantee.
Brush bar – clearing obstructions
•
If your brush bar is obstructed, it may shut 'OFF'. If this happens you
will need to remove the brush bar as shown.
•
Switch 'OFF' and unplug before proceeding. Failure to do so could
result in personal injury.
•
Remove the brush bar by using a coin to loosen the fastener marked
with a padlock until it clicks.
•
Beware of sharp objects when clearing obstructions.
•
Replace the brush bar and secure it by tightening the fastener until it
clicks. Ensure it is fixed firmly before operating.
•
Clearing brush bar obstructions is not covered by your guarantee.
•
Your machine has carbon fibre brushes. Take care if coming into
contact with them, as they may cause minor skin irritation. Wash your
hands after handling the brushes.
Emptying the clear bin
•
Empty as soon as the dirt reaches the MAX level – don't overfill. Using
the machine when the dirt is above the MAX line may cause the dirt to
reach the filter and more frequent maintenance will be required.
•
Switch 'OFF' and unplug before emptying the clear bin.
•
To remove the cyclone and clear bin unit, push the red button on the
top of the carrying handle, as shown.
•
To release the dirt, ensure the cyclone and clear bin unit is kept vertical
then firmly push the red button once more.
– The bin will slide down, cleaning the shroud as it goes.
– The bin base will then open.
– For stubborn dirt trapped in the cylinder, move mechanism up
and down until clear (please refer to 'Emptying the clear bin and
optional bin removal' illustrations).
•
To minimise dust/allergen contact when emptying, cover the clear bin
tightly in a dust proof bag while you empty.
•
Remove the clear bin carefully from the bag.
•
Seal the bag tightly and dispose.
•
Close the clear bin by pushing the bin base upwards. Ensure that the
bin base clicks and the clip is securely in place.
•
Locate the base of the clear bin onto the front of the main body and
lower the cyclone down until it clicks into place.
•
In the event the clear bin unit does not open automatically, use the
small, silver release catch located towards the base of the clear bin
unit (see 'Emptying the clear bin' illustrations).
Cleaning your clear bin
In the event that it is necessary to clean the clear bin:
•
Remove the cyclone and clear bin (see 'Emptying the clear bin') and
push the red cyclone release button.
•
Pull the silver bin release button and slide the clear bin off the spine of
the cyclone.
•
Please refer to 'Emptying the clear bin and optional bin removal'
illustrations for additional bin removal and replacing guidance.
•
Clean the clear bin with a damp cloth only.
•
Do not use detergents, polishes or air fresheners to clean the clear bin.
•
Do not put the clear bin in a dishwasher.
•
Do not immerse the cyclone in water or pour water into the cyclones.
•
Ensure the clear bin is completely dry before replacing.
32
•
To refit the clear bin:
– Insert the spine into the bin runner
– Push upwards until it clicks and then continue pushing until it
slides home.
•
Close the clear bin by pushing the bin base upwards. Ensure that the
bin base clicks and the clip is securely in place.
Looking after your Dyson machine
•
Do not carry out any maintenance or repair work other than that
shown in your Dyson User manual, or advised by the Dyson Helpline.
•
Only use parts recommended by Dyson. If you do not, this could
invalidate your guarantee.
•
Store the appliance indoors. Do not use or store it below 3°C (37.4°F).
Ensure the appliance is at room temperature before operating.
•
Clean the appliance with a dry cloth only. Do not use any lubricants,
cleaning agents, polishes or air fresheners on any part of
the appliance.
•
If used in a garage, always wipe the base of the floor tool and base of
the appliance with a dry cloth after vacuuming to clean off any sand,
dirt or pebbles that could damage delicate floors.
Disposal information
•
Dyson products are made from high grade recyclable materials.
Recycle where possible.
•
This symbol indicates that this machine should not be disposed with
your general household waste. To prevent possible harm to the
environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources. When this machine has reached the end of its serviceable
life, please take it to a recognised WEEE (Waste Electrical and
Electronic Equipment) collection facility such as your local civic
amenity site for recycling. Your local authority or retailer will be able to
advise you of your nearest recycling facility.
Online support
•
For online help, general tips, videos and useful information
about Dyson.
UK: www.dyson.co.uk/support
ROI: www.dyson.ie/support
Product information
Please note: small details may vary from those shown.
Compatibility with previous Dyson tools and accessories
•
Your new machine comes with the latest Dyson technology. As such it
is equipped with the latest Quick release catches that allow quick and
easy tool or accessory changes. However, this makes it incompatible
with previous generations of Dyson products.
•
An adaptor which makes your new machine compatible with older
Dyson tools and accessories is available by contacting your local
Dyson helpline (see 'Dyson Customer Care' section for contact
details).
•
Availability varies from country to country.
Guarantee terms and conditions
Dyson customer care
Thank you for choosing to buy a Dyson appliance.
After registering your 5 year guarantee, your Dyson appliance will be
covered for parts and labour for 5 years from the date of purchase,
subject to the terms of the guarantee. If you have any queries
regarding your Dyson appliance, visit www.dyson.co.uk/support (UK)
or www.dyson.ie/support (ROI) for online help, general tips and useful
information about Dyson.
Alternatively, you can call the Dyson Helpline with your serial
number and details of where and when you bought the machine.
Werbung
Inhaltsverzeichnis
