Transmitter Setup - Horizon Hobby hobbyzone AeroScout S Bedienungsanleitung

WARNING: Before proceeding further, remove the propeller and spinner from the motor shaft. Never attempt
to program the radio components, assemble the aircraft or perform maintenance of any kind without
removing the propeller. Serious injury could result if the motor starts inadvertently with the propeller still attached.
1. Ensure the fl ight battery is NOT connected to the aircraft.
2. Hold the motor can fi rmly to keep it from rotating.
3. Twist the propeller and prop nut clockwise to
loosen them from the motor shaft.
4. Remove the propeller, prop nut and prop washer.

Transmitter Setup

If using any DSMX transmitter other than the included DXe (3 position gear
switch, RTF only) the radio will have to be confi gured correctly for the SAFE
system to work properly.
• SAFE Flight mode is selected using Channel 5 signal (high, middle, low)
• Panic mode is selected with Channel 6 signal (high, low)
Refer to your transmitter's manual for more information about transmitter setup.
If using a 2 position switch for SAFE fl ight modes, only Beginner and
Experienced modes will be active.
Any DXe Transmitter that was not included with a HBZ AeroScout RTF will need
to be programmed using the Spektrum Programmer (SPMA3065) to function
correctly with this aircaft. Visit www.spektrumrc.com to download the correct
program for this aircraft.
All manuals and user guides at all-guides.com
Set Aileron, Elevator, and
Rudder Rates to:
DX6
DX6e
DX8
DX9
iX12
DX20
5
Computerized Transmitter Setup
(DX6 Gen2, DX6e,DX7 Gen2, DX8 Gen2, DX9, iX12, DX18 and DX20)
Start all transmitter programming with a blank model
(do a model reset), then name the model.
HIGH 100%
LOW 70%
Go to the SYSTEM SETUP
Set MODEL TYPE: AIRPLANE
Go to CHANNEL ASSIGN:
click NEXT to go to Channel Input Confi g:
GEAR: B, AUX1: I
Go to the FUNCTION LIST
Go to Throttle Cut:
set to Switch H, Position: –130
Switch H operates Throttle Cut, position 0 is
normal and position 1 cuts power to the throttle.
Switch B operates the 3 SAFE Plus modes
Resulting in:
(0 beginner/1 intermediate/2 experienced).
Button I operates PANIC mode.
EN
AeroScout S