Installation; Points To Be Paid Attention To When The Relocation Of The Appliance; Before You Start The Appliance - Beko RSSE265K30SN Bedienungsanleitung

3

Installation

B
The manufacturer will not be liable
for any event caused by disregarding
the information supplied in this user
manual.
Points to be paid attention
to when the relocation of
the appliance
1. Your appliance should be unplugged.
Before transportation of your
appliance, it should be emptied and
cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside
your appliance should be fixed
with adhesive tape and secured
against impacts. Packaging should
be adequate and the transportation
rules on the package should be
strictly observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the
appliance,
Check the following before you start
to use your appliance:
1. Clean the interior of the appliance as
recommended in the "Maintenance
and cleaning" section.
2. Connect the plug of the appliance
to the wall socket. When the fridge
door is opened, fridge internal lamp
will turn on.
3. When the compressor starts to
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give
rise to noise, even if the compressor
is not running and this is quite
normal.
4. Front edges of the appliance may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
Condenser of your refrigerator is
on the rear side. In order to increase
the energy efficiency by minimizing
the power consumption, the upper
part of the condenser on the rear
side of the product must be pulled
backwards and locked as shown in
the figure. When the condenser is
pulled back, the right and left upper
holders are locked and the position
of the condenser is fixed.
9
EN