Using A Chest-Belt; Cleaning And Care - Skandika Morpheus Bedienungsanleitung

USING A CHEST BELT /

CLEANING AND CARE

Using a chest-belt

The computer is equipped with a built-in receiver for the wireless receipt of the pulse freqeuncy with a compa-
tible SKANDIKA chest-belt (frequency: 5.3 kHz, not included in the scope of delivery). Recommended range:
100 - 150 cm.
If you want to transmit your pulse frequency via chest-belt, follow these instructions:
1. Make sure, the correct battery is inserted into the chest belt (button cell of type CR-2032, 3 volts).
Battery replacement: Open the battery case cover on the back side of your transmitter (you may use a coin
for easier handling) and replace the old battery by a tting new one. The „+" symbol should point upwards.
Make sure, the sealing ring ist correctly placed. Close the case cover properly.
2. The transmitter needs to be attached to the belt with the 2 buttons. Moisten the electrodes slightly before
wearing the belt. This increases the contact sensibility and enables a better wireless signal transmitting.
3. Put on the chest belt and make sure the electrodes are touching your breast directly. You may adjust the
belt to a comfortable length. However, the electrodes must have contact with your skin in order to measure
your heart rate correctly.
4. The 5.3 kHz-chest-belt communicates with the computer via the built-in receiver. It may last up to one mi-
nute before a correct display can be seen.
Safety hint:
Do not use the chest-belt if you have a pacemaker, unless you double-checked with the producer of the pace-
maker and with your doctor!
Battery-Disposal:
Batteries should not be considered as regular garbage. As consumer you are obliged to return
nished batteries. The nished batteries can be returned to a collection base at your residential area or at
places, where batteries can be bought.
Cleaning and care
• Before cleaning the appliance, make sure that the appliance is switched o .
• Clean the device with a slightly damp cloth only. Never use brushes, aggressive cleaning
agents, petrol, thinners or alcohol. Rub the device dry with a clean dry cloth.
• Wait until the device is completely dry before using it again.
52