After Use; Filter Changing And Dust Container Cleaning; 1- Spilling Rubbish From The Dust Compartment Subassembly - Fakir INTRA Benutzeranleitung

EN
ATTENTION!
If you leave your work area, switch off
the appliance.

After Use

WARNING!
Follow the steps below as soon as you
stop vacuum cleaning. Never leave the
appliance unattended.
1
• Press the foot button "On/Off" to switch off the
vacuum cleaner.
• Remove the plug from the mains socket.
• Press the foot button "cable rewind" to reel in
the cable.
Gently guide the cable with your hand until the
cable has been completely wound.
18
3
INTRA
NOTICE!
Only use original Fakir filters.
This is the only way to ensure that the
excellent filter properties of the vacuum
cleaner are utilised.

Filter changing and dust container cleaning

When the dust container or filters are full or if the
accessories are blocked (hose, pipe, nozzle)
suction performance will decrease. In this case,
clean the dust container or blocked filter or
remedy the blockage.
(Pls see page 20 Troubleshooting)
1- Spilling rubbish from the dust compart-
ment subassembly
Always operate the cleaner with the dust
compartment subassembly whole installed.
The dust container must be emptied if the
window of the filter indicator turns fully red when
the cleaner is operating at maximum power and
the nozzle is raised from the floor.
1
3
1. After removing the flexible tube, handhold
handle and press the locking button.
2. Take out the dustcup.
3. Push the opening bar by your thumb and lift
up the lid
4. Carry away the dust-glass cap and Spill
rubbish
5. Clean the dirt from deep inside and replace it.
6. The container can be washed under water but
cassette filter must be taken off.
2
4