Kenwood CMOS 200 Bedienungsanleitung Seite 8

Camera Setting (CMOS-300 only)
Switch Unit Operation
The switch unit can be used to switch the image
display mode, view/hide the guideline display and
adjust the camera.
View button
• Switches the image display mode.
• Select an item in the setting mode.
• Press and hold to display or hide the guidelines.
+/− button
Moves across the setting mode
items or sets an adjustment value.
Preparation Before Camera Setting
1
Stop the vehicle.
In a parking space with white lines and tire
stoppers, park the vehicle in the center of the white
line frame.
2
Advance the vehicle.
• Move the vehicle forward until the entire parking
space can be viewed in the camera image.
• Be sure to apply the parking brake and push the
brake pedal so that the vehicle is completely
stationary. Perform the setting in a place that will
not cause nuisance to other people.
8
|
CMOS-300/CMOS-200
Camera Setting Procedure
1
Complete all of the required connections in
advance.
2
Display the camera video.
Some video monitors may switch automatically to
the external video input function. For details, read
the instruction manual for your video monitor.
3
Press and hold the view and + buttons of the
switch unit simultaneously to enter the camera
adjustment mode.
4
First select the positioning of the camera.
Use the + or – button to select an item and press
the view button to enter the selection.
• When using the camera as the rearview camera,
select [OK].
• When using the camera as the front camera, select
[Switch to Normal Image Display] and then select
[OK].
• Selecting [Reset All] resets all of the camera
settings to the defaults.
5
Select a camera adjustment item and adjust it.
The following items are available for camera
adjustment.
1. Overhead view image adjustments
(Centering, Right-and-Left angle, Up-and-Down
Angle)
2. Wide view guideline adjustments (Size,
Horizontal direction, Vertical direction, Red Line
Position Setting)
3. Overhead guideline adjustments (Size,
Horizontal direction, Vertical direction, Red Line
Position Setting)
To select an item:
Press the + or – button to select an item and press
the view button to enter the selection. When an
adjustment item is selected, the frame of its icon
turns from blue to red.