Operation - LIVARNO 1002-W Bedienungs- Und Sicherheitshinweise

or corner mounting) in place by inserting
the screws (25mm)
holes / and firmly tightening them.
17 18
Check that the wall bracket is fixed firmly in
place.
Unscrew the gland nut
„
spotlight.
Remove the screws
„
and pull it away far enough to be able
12
to access the terminal strip
the cover plate.
Feed the power supply cable first through
„
the gland nut , then through the cable
11
grommet , and finally through the cover
15
plate before starting installation.
12
Connect the power supply cable to the
„
terminal strip . Make sure that the
6
individual cable cores are correctly
connected. Take care to ensure that the
earth conductor
9
the other conductors so that if the cable is
torn away from the outdoor spotlight, the
earth conductor comes away last. Connect
the neutral conductor
marked N and the live conductor
terminal marked L so as to avoid incorrect
installation and consequent damage to the
product or personal injury (see Fig. C).
Secure the connecting lead (inc. outer
„
sleeve) with the strain-relief clamp
Fig. C).
Feed the terminal strip
„
casing and screw the cover plate
onto the outdoor spotlight.
Position the cable grommet
„
cover plate and nut so as to obtain the best
possible seal and fix it in place by
hand-tightening the gland nut
Slot the outdoor spotlight onto the wall
„
bracket from above and screw it to the
16
bracket using the two screws (10mm)
(see Fig. G).
Note: The screw heads of the cover plate
must be countersunk so that the outdoor
spotlight can be fitted onto the wall bracket.
Switch the circuit-breaker for the circuit back
„
through the guide
19
from the outdoor
11
from the cover plate
14
attached to
6
is made longer than
to the terminal
10
to the
8
(see
7
back into the
6
back
12
between the
15
�
11
21
on or replace the fuse.
Setting the beam width
Tilt the outdoor spotlight to the desired
„
position (see Fig. H).
z Operation
The outdoor spotlight is operated by means
of the three control knobs on the bottom end
of the light (see Fig. B).
Set the switch to position "I" to activate
„
13
Always On mode. Set the switch
position "0" to activate Automatic mode
(motion sensor). In this mode the following
settings are possible.
Setting the detection range
Turning the SENS control
„
increases the detection range so that the
motion sensor responds to movement as far
away as approx. 12m (see Fig. B).
Turning the SENS control
„
decreases the detection range so that the
motion sensor only responds to movement
as close as approx. 0.5m (see Fig. B).
Setting the burn time
Turning the TIME control
„
increases the illumination time (max.
1 minute) (see Fig. B).
Turning the TIME control
„
decreases the illumination time (min.
10 seconds) (see Fig. B).
Setting the sensitivity of the twilight
sensor
Turning the LUX control
„
increases the sensitivity so that the motion
sensor will respond even in brighter
ambient light conditions (e.g. daylight) (see
Fig. B).
to
13
clockwise
5
anticlockwise
5
clockwise
4
anticlockwise
4
clockwise
3
GB/IE/NI/CY/MT
53