Assembly And Installation - LIVARNO 1002-W Bedienungs- Und Sicherheitshinweise

Any protective cover that is split or cracked
„
must be replaced.
Never look directly into the light source.
„
Never point the light into the eyes of other
„
people or animals.
PLEASE NOTE! Incorrect handling of the
„
light may lead to damage to the product.
Check the screw fixings at regular intervals.
z Assembly and installation
Please note: remove the product from its
packaging.
Check that all package contents are
„
present.
Check whether the outdoor spotlight or
„
individual parts are damaged. If that is the
case, do not use the outdoor spotlight.
Please contact the retailer via the service
address indicated on the warranty card.
Choosing the installation position
Fix the outdoor spotlight at a height of 2-3m
„
to a sturdy wall that is not subject to
vibration.
Only install the outdoor spotlight outside of
„
the hand-contact zone so as to prevent it
being touched.
Position it at least 20cm away from other
„
objects so as to ensure good ventilation.
If possible, mount the outdoor security in a
„
position where it will not be exposed to dirt
or dust and is protected from rain (e.g.
under a roof overhang), sun and other
weathering effects.
Take care to ensure that the outdoor
„
spotlight is not affected by interference from
another light source.
Do not point the motion sensor
„
heating fans, air conditioning units,
swimming pools or other objects with
rapidly changing temperatures.
Do not point the motion sensor towards
„
trees, bushes or areas where moving
animals can be detected.
52
GB/IE/NI/CY/MT
Take into account that the motion sensor
„
responds primarily to movement across its
field of view and not so sensitively to
movement directly towards or away from it.
Mounting the outdoor spotlight
RISK OF ELECTRIC SHOCK! Incorrect
electrical installation or a power supply
voltage that is too high can potentially cause
electric shocks. Failure to take account of
that risk endangers not only yourself but
other people as well.
You should only have the product installed
„
by a qualified electrician.
When drilling the fixing holes, take care to
„
avoid drilling through wiring, cables or
pipes (e.g. water or gas pipes).
Make sure the power supply is
„
disconnected during installation. Switch off
the circuit-breaker for the circuit concerned
or remove the fuse. Safeguard it against
being switched on again (e.g. by
displaying a warning notice).
Observe the correct polarity when
„
connecting the wires to the terminal strip
. Refer to Figure C for details of how to
6
connect the wiring/supply cable to the
terminals.
Make sure that the mains power supply is
„
switched off.
The outdoor spotlight can be mounted
„
either on a straight wall or on a corner
using the wall bracket
Please note: make sure that you mount the
wall bracket the correct way round. Refer to
Figure F for guidance.
With the wall bracket
„
mounting position, mark the positions on
towards the wall for the fixing holes using either the
2
guide holes
corner) or guide holes
straight wall) (see Figs. E and F).
Drill two holes (dia. 6mm) and insert the
„
matching wall plugs
Screw the wall bracket
„
(see Fig. F).
16
in its intended
16
(for mounting on building
18
(for mounting on
17
(see Fig. F).
20
(for straight-wall
16