geo-FENNEL DuoCrossPointer3 HP Bedienungsanleitung Seite 13

OPERATION
Set up the laser
1. on the floor
or
2. fix the laser with the mount supplied with the kit and connect it with a tripod
or
3. fix the magnets of the mount onto a magnetic surface (steel plate)
or
4. set up the laser in a hanging position by means of the hole of the mount
or
5. fix the lase on a column by means of the fixing strap
POWER ON
Switch the instrument on by turning the ON/OFF knob in position ON. The instrument is now ready for
use. An audible and optical (blinking lines) alarm indicates if the instrument was set up outside of the
compensator range. In this case set up the instrument on a more even surface.
To switch the instrument off turn the ON/OFF knob back to the OFF position. The instrument is now
switched off and the compensator is blocked to avoid damages during transport.
Note:
During transport the ON/OFF knob (compensator lock) must be set to OFF . Disregard may lead to
damages of the compensator.
All manuals and user guides at all-guides.com
Off
EN
On
D
13