Commissioning; Aesi Operation; Monitoring And Warnings - SLAT AESI C24 Bedienungsanleitung

Open the main breaker before connecting
The earth have to be connect to the board for security reason.
Connect the battery wires to the terminal strip, but do not connect the battery terminals.
After the electrical connections are made (mains, loads and batteries).
1. Close the upstream mains circuit-breaker.
2. Check the load output voltage. The LED on the motherboard turns red.
3. Connect the battery terminals.
4. Check that the LED confirming correct motherboard operation is illuminated:
5. Connect the ground wire and the wire ribbon (if equipped).
6. Close the cover.
Your equipment is in operation when the 3 green LEDs, ( mains, battery and charger, are illuminated)

15.1 Monitoring and warnings

Monitoring
Mains fault (main supply):
If there is no mains.
Charger fault:
If there is no voltage on user output 1.
-
If there is no voltage on user output 2.
-
If output voltages are low (overloaded product).
-
If mains fuse is blown / there is no mains fuse.
-
- If the product is out of order.
Battery fault (auxiliary supply):
If there is no battery (a test will performed every 30s during the first 20min after switch on and every 15min
-
(maximum time interval) then after. In case a fault is detected, another test will be performed every 30s until
20min have passed from fault end.
If battery voltage < 1.85V/elt+/-3%.
-
If internal impedance is too high (a tests will be performed every 4h (maximum time interval) on a loaded
-
battery). Limit values are:
Warnings
Housing version:
3 lights indicate these 3 faults.
Yellow led warning if fault, green if not.
All manuals and user guides at all-guides.com

14 Commissioning


all OK: green,

any fault: red

15 AESI operation

24V
0.65 0.65
Yellow
Green
Green
Figure 1: Leds board in case of mains fault
2A 3A
17