Blumfeldt 10030690 Bedienungsanleitung Seite 28

Digital displayer: Display the power setting of the working component.
It always displays the power setting of the upper tube if the heating
tube is turned on.
Buttons have the same function as those in the control panel
Operation:
1. Plug in the powder cable, a "Beep" sound is heard. The heater is in
"Stand By" status, the ON/OFF is a blue light.
2. Press the ON/OFF button and the light will be white, and the heater
switch to a working status. The heating tube and the LED light are preset
in power 3.
3. Press the tube or light button, the relative tube or light and the digital
display will flash for 5 seconds, press the same button to adjust the
heating or light power while the power section is showed in the display.
The flashing will stop after 5 seconds and the adjustment is finish.
4. If you want to turn off only one tube or light, press the relative button
and press ON/Off button immediately. To turn the tube or the light on
again, push the relative button.
5. Turn off all tubes and light by pressing ON/Off button, the heater turns to
"Stand By" status.
All manuals and user guides at all-guides.com
28