Risk Of Leakage From Batteries; Rechargeable Batteries; Assembly And Installation; Mounting The Spotlight - LIVARNO home 1020-B Bedienungs- Und Sicherheitshinweise

Never throw batteries/rechargeable
„
batteries into fire or water.
Do not expose the batteries/rechargeable
„
batteries to mechanical stress�
z Risk of leakage from
batteries/rechargeable
batteries
Avoid exposing (rechargeable) batteries to
„
extreme conditions and temperatures, e�g�
radiators or direct sunlight�
Avoid contact with skin, eyes and mucous
„
membranes! In the event of skin contact
with battery acid, rinse the affected area
immediately with plenty of clean water and
seek medical advice immediately!
WEAR PROTECTIVE GLOVES!
„
Leaking or damaged batteries/
rechargeable batteries can cause
chemical burns if they come into contact
with the skin� Therefore, wear suitable
protective gloves in such cases�
In the event that a battery leaks, remove it
„
from the product immediately to avoid
damage�
z Assembly and installation
Please note: remove all packaging material
from the product� Decide prior to mounting
where the product is to be mounted. Before
drilling the fixing holes, satisfy yourself that
there is no danger of drilling into or
damaging gas or water pipes or electricity
cables in the position where you are about
to drill the holes� Use a drill to drill the holes
into the masonry� Observe all safety
instructions provided in the operation and
safety manual for your drill� Otherwise there
is a risk of serious or fatal injury from electric
shock�
Please note: the fixings included are
suitable for conventional solid masonry� You
should check independently what kind of
32
GB/MT
fixings are best suited for the surface on
which you intend to mount the light� If
necessary, you should seek the advice of an
expert�
When deciding where to mount the
light, pay attention to the following:
Ensure the product illuminates the desired
„
area� Make sure that the motion sensor
covers the desired area�
The motion sensor has a maximum
„
detection range of 10m with a field of view
of approx� 120°�
Ensure that the motion sensor
„
position where street lighting will shine on it
at night� This may impair the function�
The recommended installation height is 2 to
„
4m� If possible, mount the Spotlight in a
position where it will not be exposed to dirt
or dust and is protected from rain (e�g�
under a roof overhang) and other
weathering effects�
Please note: the solar panel
positioned where it will be exposed to as
much direct sunlight as possible� Even partial
shade during the day can significantly
impair the charging process�
Orientation:
The optimum alignment is facing south�
Choose an orientation facing slightly to the
west rather than slightly to the east�
z Mounting the Spotlight
Transfer the positions of the guide holes
„
/ to the mounting point on the wall�
13
Drill two holes (dia� 6mm) and insert the
„
matching wall plugs
G).
Mounting model 1020-B
Screw the screws
„ 7
leaving a gap of approx� 3mm between the
screw head and the wall (see Fig� C)�
Slot the guide holes
„
4
is not in a
4
should be
2
3
(see Figs� C and
8
into the wall plugs
8
over the screws and
3
,