Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the slide washer, washer and collar nut
over the hose and threaded base and tighten
the collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation
valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Technical Data
T h i s
m i x e r
s e r i e s - p r o d u c e d
waterdimmer
(flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 0,3 MPa
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temperature: 65° C
Test certificate 38040000:
The aerator is not equal to DIN EN 246.
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the waterdimmer
(7a) located behind the aerator must be removed.
English
w i t h
7 l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
WRAS
®
Spare parts (see page 4)
1
handle for cold / hot water
2
color-ring for cold / hot water
3
handle fixing set
4
shut off unit, cold
5
shut off unit, hot
6
spout cpl. 38040000/38047000 97363000
7
aerator cpl.
8
fixing set
9
connection hose 350 mm
10 pop up rod
11 spout cpl. 38222000
12 ball joint
13 aerator cpl.
14 spout cpl. 38045000
Special accessories
X
special tool set
(order as an extra)
38093000
96319000
94184000
94008000
94009000
96911000
13961000
13099000
94083000
97364000
97362000
97360000
97688000
58085000
Werbung
