Conformity To Standards - Stahl ispac 9147 0-99-10 Serie Betriebsanleitung

Operating Instructions
• The apparatus may be connected only to devices in which no voltages higher than 253 V
AC (50 Hz) may occur.
• The safe maximum values of the connected field device(s) must correspond to the
values of the data sheet or the EC-type examination certificate.
• Interconnecting several active devices in an intrinsic safety circuit may result in other
safe maximum values. This could endanger the intrinsic safety!
•
ATTENTION: electrostatic sensitive components. Unload yourself at grounded
metal parts or use an ESD-wristband before working with the ISpac.
• National safety and accident prevention regulations.
• The generally recognised technical regulations.
• The safety guidelines in these operating instructions.
• Any damage can invalidate the explosion protection.
Use the device in accordance with the regulations and for its intended purpose only (see
"Application").
With incorrect or unauthorized use or non-compliance with these instructions the
intended protection can be impaired, the warranty provision is invalidate on our part in
these cases.
No changes to the devices or components impairing their explosion protection are
o
permitted.
Furthermore, the device may only be operated if it is undamaged, dry and clean.
o
Should there be any question about the correct handling of the module, please contact R.
STAHL Schaltgeräte GmbH, Am Bahnhof 30, 74638 Waldenburg, Germany, telephone
+49-7942-943-0, or contact one of our offices or representatives see www.stahl-ex.com.
4

Conformity to standards

The information about the conformity to standards can be found in the manufacturer's
declaration of conformity in the appendix of this document.
The current EC-Type Examination Certificate can be downloaded from the Internet
www.stahl-ex.com .
14
Vibration Transducer Supply Unit Type 9147
!Warning
english