Mounting And Dismounting - Stahl ispac 9147 0-99-10 Serie Betriebsanleitung

english Operating Instructions

8.3 Mounting and dismounting

a) Detachable terminals
All devices are provided with detachable terminals. A screwdriver is
needed to remove the terminals (as shown in the picture).
b) Mounting on DIN rails
Set the device on the DIN rail and tilt/snap onto the rail as depicted. Do
not set at an angle. For removal, pull the base latch out a little with a
screwdriver and remove the module.
c) Mounting on DIN rails with an already-installed pac-Bus
As depicted in the photo, set the device in position on the pac-Bus
(already mounted on the DIN rail) and tilt/snap until it locks in.
Do not tilt at an angle to either side when snapping onto the pac-Bus.
Note: In order to prevent pole reversal during installation, the pac-Bus
elements have been equipped with a keyed connection plug (see photo).
The module is fitted with a matching slot.
Dismount as described below in b).
d) Mounting in the pac-Carrier
Remove the gray cover between the black and green terminal of single
channel devices.
Make use of a screw driver in the way showed on the picture. Set
carefully into the lower gap between the cover and the enclosure and
remove the cover.
Remove the black and green terminals.
Set the ISpac modules in place as described in a) and b) and completely
tilt/snap into the pac-Carrier.
Close the red latching lever using gentle pressure. The latching lever
must engage completely.
To dismount, use a screwdriver to open the latching mechanism as
shown in the picture. The module is nudged out of the slot and can be
removed.
17
Vibration Transducer Supply Unit Type 9147