Creality 3DPrintMill Benutzerhandbuch Seite 39

Trouble-Shooting
Workflow Fault diagnosis
N
Start
Play by memory
card Seal
Display error
Y/N N File identifica- Y
codes or not
tion or not
Y
Return
N
"Home"
N Print or not Y
Y/N
Y
Heat the
hot bed
Hot bed is
N Y
Y/N
heated or not
Y
Heat the
N
nozzle
The nozzle is
N Y
Y/N
heated or not
Y
Printing when
Dislocation
or not
filament-push
Y
Filament-push
N
Y/N
or not
Y
N
The E motor
Finish N Y The gear rotates
rotates or not
N
Fault cause
Storage-card
N File naming
Other documents are
Y Y
Slicer
printed normally or not
Shaft motor
Beyond
Y Limit switch
"Home"
N Hot bed
The display of
N Thermistor
temp is normal or not
Heating tube
The display of humidity
N Thermistor
is normal or not
Slicer\Sync-
Y
hronous belt
Coupling
N
The filament is
Y Y Others
normal or not
or not
N Filament
E motor
Fault handling
１ ． Wipe Storage-card
２. Format Storage-card
３. Replace Storage-card
Change the file name to English and
number format
１ ． Move model position and slice again
２.Using repair software to repair the model
１ ． Reconnect circuit
２. Check by substitution
１ ． Reconnect circuit
２. Check by substitution
１ ． Reconnect circuit
１ ． Reconnect circuit １ ． 调平操作
１ ． Reconnect circuit
1. Reconnect circuit and lock the screws of
１ ． 调平操作
thermistor
１ ． Slice again
2. Adjusting the tension of synchronous belt
１ ． Fasten the coupling
１ ． Remove surface defects of filaments
2． Replace the filament
１ ． Reconnect circuit
２. Check by substitution
Result feedback
Problem solved
Component damage, replace
Process
continuously
result
Unknown malfunction, please
contact the after-sales
38