AVS Electronics STARLINK 4G Allgemeines Installationshandbuch Seite 24

STARLINK 4G CONNECTIONS
S IM B
CONNECTOR FOR
CONNECTION OF
THE GSM ANTENNA
As GSM interface:
•
Terminals TI and TO: C / NC output of TAMPER contact. With S3 in position 1-2.
•
Terminals X1, X2 and X3: Open Collector outputs, they give a transistorized negative (50mA max.)
As Telephone Dialler:
S IM B •
Terminals TI and TO: TAMPER input
US B
T AMP E R
T I T O
TAMPER
S IM B
US B
T AMP E R
T I T O
TAMPER
US B
T AMP E R
T I T O
With Jumper S3 in position 1 - 2 TAMPER is
•
Terminals X1, X2 and X3: can be individually programmed either as input 1, 2 and 3 normally closed, normally open or balanced by use of
a 4700 Ohm resistor, and as Open Collector 1,2 and 3 outputs with reference to negative; or both programming at the same time (the input is
directly overbalanced by the activation of the corresponding O.C.).
•
Terminals X4 (T4)/DA and X5 (T5)/DB: can be programmed individually as input 4 and 5 normally closed, normally open or balanced by a 4700
Ohm resistor.
Supplying must come by a very low security-tension circuit and having the characteristics of a source at limited power protected by fuse.
The power of the ring-generator on the device allows the activation of a limited number of ringtones. It is thus suggested to connect
a minimum number of telephone devices in cascade. This number cannot be defined as ring-consumption varies according to
the model.
BATTERY
External TAMPER between TO and - (negative):
By this connection, both opening of EXTERNAL TAMPER and TAMPER PUSHBUTTON on the board
1
are signalled
Jumper S3 in position 2 - 3
External TAMPER between TI and - (negative):
By this connection only opening of EXTERNAL TAMPER is signalled
1
Jumper S3 in position 2 - 3
Jumper between TO and - (negative):
This connection only signals the opening of the TAMPER PUSHBUTTON on the board.
1
Jumper S3 in position 2 - 3
disenabled.
- 24 -
TELEPHONE
DIALLER