Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
-
"O" means the unit is off
-
"I" low power
-
"II" medium power
-
"III" high heating power
OPERATING
Install the appliance as described in the General and Safety Information paragraphs.
If you are using the product G60012, temporarily disable the timer (5) switching the red button in
position "I". Turn the function control knob (4) to the desired position. At first use, the appliance may
emit some smoke or strange smell; this is normal and it finishes after a few minutes of use. Turn the
temperature control knob (3) clockwise until it stops. At this point, the heater turns on.
TEMPERATURE SETTING
Operate the unit by switching the temperature control knob (3) to the
highest position until the desired temperature in the room is reached.
Turn the temperature control knob (3) counterclockwise until you
turn off the product, then it will turn on periodically to maintain the
temperature.
FAN MODE
To obtain a more efficient heating, the product is equipped with an
internal fan (8) that can spread heat in the room faster. To operate, switch on the fan power button (7).
OVERHEATING PROTECTION DEVICE
If you cover the device or there is a malfunction, the product may overheat. A safety device will shut
down the unit to prevent overheating. Remove anything blocking the ventilation slots and wait for the
complete cooling of the unit, then the appliance works normally.
WORKING LIGHT
The unit is equipped with a red working lamp which lights on
when the appliance is running.
TIMER (available for mod. G60012)
24 hours timer (5) is available for the model G60012 only.
The lever for setting the timer (5) is the red one indicated in the
figure as "SWITCH".
Move the lever to position "0" to turn off the product.
Move lever to position "1" to operate the product without timer.
Move the lever to the "
Once you set the desired temperature by adjusting the thermostat (refer to the "SETTING
TEMPERATURE" paragraph), use the lever (5) to determine the hours of the day when you want to
turn on the heater.
1) Align the pointer drawn black on the timer dial with the current time.
2) Set the hours of the day when you want the unit remains off, leading towards the center of the dial
the blue seats corresponding to the hours.
3) Turn on the timer by switching the power button to"
4) Every time you disconnect the unit, black arrow must be placed back on the current time.
" position to activate the timer mode.
".
10
Werbung
Inhaltsverzeichnis
