Description; Operating - TREVIDEA G3 FERRARI G60023 HPC-F2011YL Bedienungsanleitung

surrounding objects. Pay attention: the protection grid
becomes very hot during use.
- Place the unit on solid and stable surfaces. During use,
place leave at least half a meter on each side of the unit.
- Do not use the unit near steam or water (sink, shower,
toilet ...). Do not use as a shelf support for objects.
- Do not cover for any reason, subject to overheating.
- Do not use in rooms smaller than 4 square meters.
The product is equipped with an automatic switch-off that
comes into play in case of overheating. If the product fails
during use, check that the ventilation openings are not
blocked, unplug the unit and allow to cool down for 15
minutes before operating.
WARNING: Do not use this heater in small rooms
when they are occupied by persons not capable of
leaving the room on their own, unless constant
supervision is provided.
The appliance must not be placed immediately below a
power outlet.
1. Function button I
4. Swing button
7. Resting base

OPERATING

Install the product as described in the safety information paragraph.
POWER ON
Set the temperature adjustment knob (8) to the maximum level.
Press the activation button I (1) to have low power heating (1000W).
Press both operating buttons (1 and 3) to have high power heating (2000W).
ADJUSTING THE TEMPERATURE
Operate the unit by using the temperature control knob (8) set to high until it reaches the desired temperature
in the room. Turn the knob (8) to the right until you turn off the product, then it will turn on periodically to
maintain this temperature.
OSCILLATION
If you want to activate the oscillating movement, press swing button (4) on the back of appliance.
SAFETY DEVICE AGAINST OVERHEATING
If you cover the appliance or there is a malfunction, the unit may overheat. A safety device will shut down the
unit to prevent overheating. Remove anything blocking the ventilation slots and wait for the complete cooling
of the item before operating.
DESCRIPTION G60023
2. Handle (in the back)
5. Air outlet grid
8. Temperature knob
3. Function button II
6. Main body
11