Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EXAMPLE
The fan heater will start running when:
- The fan heater is connected to the power outlet.
- The thermostat (control knob 3) is set to a higher temperature than the room one.
- The function selection knob (4) is in position "I", "II" or "III".
- The lever of the timer is in "
corresponding blue switch is in the out position.
STANDING FEET
If you wish to place the fan heater on the ground, you must mount the
supporting stands:Align the standing feet with the holes on the bottom of
the housing (9) and secure them with the screws.
WALL MOUNTING
Unplug the unit and wait for the complete cooling of each part before starting the wall
mounting procedure.
The mounting and wall installation must be done by following a few precautions.
-
The product should be placed at a minimum distance of 40 cm
from the ground and from the side walls.
-
The product should be placed at a minimum distance of 80 cm
from the ceiling.
-
Do not mount on walls subject to vibration.
-
Do not install the foot stand
The wall mounting kit includes: 4 wall plugs, 4 screws, 4
mounting brackets.
Once you have chosen the position where you want to place the
unit, follow the steps below:
-
Measure the distance between the two slots in the back of appliance, fig. 1, and mark on the wall
correspondent positions.
-
Make holes (7mm) by drilling the wall at the height of the marks and insert the wall plugs.
-
Support brackets (fig. 2) to the wall so as to correspond the hole located on the short side of the
bracket with the plugs. Screw the tabs to the wall (fig.3).
- Mount the other 2 brackets to the holes in the bottom of convector
(one on left side and one on right side), as shown in fig 5.
- Take the fan heater to place it on the wall: to this end, put the two
upper brackets into the holes in the back of the product, and then place the base of the appliance
on the lower tabs, as shown in figure 4.
- Mark the wall inn correspondence of the holes of the bottom brackets, remove the convectore and
make two holes in the wall. Insert plug in the holes.
- Mount convector to the wall again and fix the 2 lower brackets to the wall with the screws.
" position and the pointer is over an hour marks for which the
11
Werbung
Inhaltsverzeichnis
