Before Using For The First Time - Siemens TE506 Serie Gebrauchsanleitung

de en
The aromaDouble Shot function is activated
with the following settings:
Before using for
the first time
General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines)� Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit�
The water hardness setting can be adjusted
on this appliance� The factory default setting
for the water hardness is 4� Check the
water hardness with the enclosed test strip�
If the check reveals a value other than 4,
change the setting on the appliance accord-
ingly after switching on (see "Menu settings"
)�
Water hardness
Switching on the appliance
1� Remove the protective film.
2� Place the fully automatic espresso
machine on a flat, water­resistant
surface that can take its weight� Make
sure that the machine's ventilation slots
remain unobstructured�
Important: Only use the appliance in
frost-free rooms� If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation�
28
All manuals and user guides at all-guides.com
3� Pull the power cord out of the storage
4� Install the milk frother� Operate the
5� Lift the lid of the water tank (18)�
6� Remove and rinse the water tank (17)
7� Replace the water tank (17) and push it
8� Close the lid of the water tank (18)
9� Fill the bean container (1) with coffee
10� Press the power switch O / I (9)� The
11� Select the required display language
12� Place a receptacle under outlet (6a)�
13� Press the start button (10)�
The language you selected is saved�
The appliance heats up and rinses� Some
water will run out of the coffee outlet�
compartment (21) and plug in� Adjust
the length of the cable by pushing it
back in or pulling it out� The easiest way
to do this is to place the appliance so
that its back is flush with the edge of the
counter and either pull the cable down-
ward or push it upward�
machine only after the milk frother (6)
has been fully assembled and installed�
and fill it with fresh cold water.
Do not fill above the max mark�
firmly downward into place.
again�
beans (for preparation using ground
coffee, see "Preparation using
ground coffee")�
display (16) shows the menu for setting
the display language�
with the upper rotary knob (15)�
The following languages are available:
Deutsch
English
Français
Italiano