Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WHEELS:
To attach the wheels, put onto axle, push down and hold
metal half circle loop located in the centre of the wheel click
into position.
Give the wheel a pull to make sure its locked into place.
Never pull the clip / split pin out of the socket!
The wheels are ball-bearing - the axle must not be greased
or oiled. The bushing should be fixed on the axle and the
wheel should turn only on the ball bearing. The grease on
the axle at the time of delivery serves only to protect
against rust and simpler initial assembly of the wheels.
Airwheels take a maximum of 1.5 Bar of pressure.
If you notice a brownish surface on the axles during
NOTE:
the initial installation of the wheels - do not be alarmed! This
is a residue from the chrome plating process, which can
easily be wiped off!
BRAKEBAR:
To engage the brake, push down on the middle of the bar
until it grips the wheels. (picture 10)
To disengage, reverse the procedure. (picture 11)
WARNING Always engage the brake when putting
the child in or out of the pram.
HANDLE-HEIGHT ADJUSTMENT:
On some models this part on the handle is available. For the
changing of position simply press the button on both sides
of the handle & swing the handle into the position
comfortable for use.
NOTE:
This part also makes it possible to fold the
pushchair smaller.
Wheels & brake
Werbung
