Küppersbusch IGV6504.0 Benutzerinformation Seite 23

Adjust the water softener to the water hard-
ness in your area. If necessary, contact your
local water authority.
Water hardness
°dH °TH
51 - 70 91 - 125
43 - 50 76 - 90
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
< 4 < 7
1) No use of salt required.
You must set the water softener man-
ually and electronically.
Manual adjustment
The appliance is set at the factory at po-
sition 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position
1 or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.
Electronic adjustment
The water softener is set at the factory
at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
All manuals and user guides at all-guides.com
mmol/l Clarke
9,1 - 12,5 64 - 88
7,6 - 9,0 53 - 63
6,5 - 7,5 46 - 52
5,1 - 6,4 36 - 45
4,0 - 5,0 28 - 35
3,3 - 3,9 23 - 27
2,6 - 3,2 18 - 22
1,9 - 2,5 13 - 17
0,7 - 1,8 5 - 12
< 0,7 < 5
3. Press and hold the programme selection/
4. Release the programme selection/cancel
5. Wait until programme indicator light B
6. Press the programme selection/cancel
7. Press the programme selection/cancel
8. Press the on/off button to save the oper-
Water hardness setting
manually
2
2
2
2
2
2
1
1
1
1)
1
cancel button.
button when programme indicator light A
starts to flash and programme indicator
light B comes on.
goes off.
– Programme indicator light A starts to
flash.
– The end-of-programme indicator light
starts to flash.
button one time.
– Programme indicator light A starts to
flash.
– The setting function of the water soft-
ener is activated.
– The end-of-programme indicator light
flashes to show the level of the water
softener.
Example: 5 flashes, pause, 5 flashes,
pause, etc. = level 5.
button one time to increase the water
softener level by one step.
ation.
23
electronically
10
9
8
7
6
5
4
3
2
1)
1