Use Of The Appliance; Setting The Water Softener - Küppersbusch IGV6504.0 Benutzerinformation

22
With the half-load button pressed the
time duration and the consumption of
water and energy are reduced.
Programme indicator lights A and B
Apart the selection of the corresponding
washing programme, these lights have an
auxiliary functions:
• The adjustment of the water softener level.
• Deactivation/activation of the audible sig-
nals.
Setting mode
The appliance is in setting mode when all the
programme indicator lights are off and the
end-of-programme indicator light flashes.
The appliance must be in setting mode for
these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
The appliance is not in setting mode when
only one programme indicator light is on.
Cancel the programme to go back to the
setting mode. Refer to the chapter 'Setting
and starting a washing programme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• When the appliance has a malfunction.
The activation of the audible signals is set at
the factory.

Use of the appliance

Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.

Setting the water softener

The water softener removes minerals and
salts from the water supply. Minerals and
salts can have bad effect on the operation of
the appliance.
Water hardness is measured in equivalent
scales:
All manuals and user guides at all-guides.com
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
3. Press and hold the programme selection/
4. Press the programme selection/cancel
5. Wait until programme indicator light A
6. Press the programme selection/cancel
7. Switch off the appliance to save the op-
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the end-of-
5. Set the correct washing programme for
6. Fill the detergent dispenser with the cor-
7. Start the washing programme.
• German degrees (dH°).
• French degrees (°TH).
• mmol/l (millimol per litre - international unit
• Clarke.
mode.
cancel button until programme indicator
light A flashes and programme indicator
light B comes on.
button again.
– Programme indicator light A comes on.
– Programme indicator light B starts to
flash.
goes off.
– Programme indicator light B continues
to flash.
– The end-of-programme indicator light
comes on.
The audible signals are activated.
button again.
– The end-of-programme indicator light
goes off.
The audible signals are deactivated.
eration.
programme indicator light comes on.
the type of load and soil.
rect quantity of detergent.
If you use detergent tablets, refer to the
chapter 'Use of detergent'.
for the hardness of water).