First Use; Use Of Steam Functions - Hoover H-OVEN STEAM 700 PLUS Bedienungsanleitung

2.3 First Use

ABOUT APPLIANCE BEFORE FIRST USE
- Before the first use, fill the tank with 300 ml of water when the oven
is empty and press the steam icon to start the engine.
- Select a cooking program (steam program or ventilated one).
WARNING
- Only with a ventilated program the steam icon works.
- The temperature of the water in the tank should be 22 ° C at room
temperature.
PRELIMINARY CLEANING
1. Clean the oven before using for the first time. Wipe over external
surfaces with a damp soft cloth.
2. Wash all accessories and wipe inside the oven with a solution of
hot water and washing up liquid.
3. Set the empty oven to the maximum temperature and leave on
for about 1 hour, this will remove any lingering smells of newness.

2.4 Use of steam functions

WATER DRAWER
Figure 1
1. Please push slowly and pull the drawer in order to pour water.
(Figure 1)
2. Pour water with a jug or remove the tank and fill in with the water
from the sink. (Figure 2)
3. Please insert 300 ml of water.
4. Select from steam functions the proper cycle among fish, meat,
vegetables , pasta&bakery.(Figure 3)
5. For more details, please refer to section n. 3.4.
Figure 3
6. Set temperature and timing according to the recipe.
7. Please push start.
NOTE: The display will show "COOKING". Some drops of water
could fall into the cavity even during cooking. It's normal and it
doesn't affect proper cooking.
- At the beginning of the cycle the pump will make a noise for
around 1 minute: it's normal working.
- At the end of cooking a buzzer will sound and the display will
show: "COOKING ENDED".
- Before starting another steam cooking cycle, please wait around
60-90 minutes that the oven completely cooled down.
- The possible remaining water will be loaded back to the tank after
one hour from end of cooking. A buzzer will notify.
- The pump will make a noise for around 1 minute: it's normal
working.
8. Discharge water by extracting the tank.
Figure 2
WARNING
- Water should only be filled into the tank, no liquids other than
water.
- Tank must be filled to 300 ml.
- The water in the tank must be drained after each use.
- If water filled less than 300 ml, steam generation can be finished
before steam program ended.
- If water filled more than 300 ml, water presence can be occur at
the end of steam program.
- Please close the drawer properly. If the drawer is not closed
properly, a message will appear on the display: "tank is missing".
- Water must be at room temperature.
- Do not open the drawer into cooking.
- Do not add water during cooking cycle.
- Avoid to open the door during cooking to ensure efficiency and
steam cooking performances .
STEAM BUMP
By touching the electronic button it is possible to steam all the water
at once.
It's ideal to cook vegetables or fish in the gentlest and healthiest
way since the needed amount of fat and oil is reduced.
1. The user can have a steam bump by pressing the steam button.
2. When the button is pressed the steam icon blinks.
3. During the steam generation the icon is switched on without
blinking; at the end of the steam generation the steam icon is
switched off.
4. The first time that the steam button is pressed, the screen askes
to load the water.
5. Follow the steps at paragraph "2.4 Use of steam functions"
before starting the cycle.
6. Push for a maximum of 5 times the steam button on the user
interface to inject steam into the cavity.
WARNING
Take note that this function is only allowed in combination with fan-
assisted cycles which are ;
- Bottom heating + fan
- Convection + fan
- Grill +fan
- Multilevel
SANIFICATION CYCLE
• Sanification is useful to sterilize the cyrcuit. A message will appear
in order to activate it at first use, then the user can decide whether
to use it or not.
• It is required to add disinfectant detergent to water and afterwards
the oven will guide the user in the whole process.
• Sanification cycle is present in the cleaning system menu.
DESCALING
• After 10 times water loaded, the display shows the message
cycles "DESCALING SUGGESTED".
• After 15 times water loaded, the display shows the message
"DESCALING MANDATORY" and the steam function is no more
available if the user doesn't perform a descaling cycle.
• Descaling cycle is present in the cleaning system menu.
• Descaling cycle must be performed with a commercial food
compliant descaling product.
EN 07