General Information - resideo Braukmann CBU142 Einbauanleitung

1.6 Safety instructions for the operator/
operating personnel
• Provide on-site protection against contact for hot,cold,
and moving parts and check if they function properly.
• Do not remove the protection against contact during
operation of the pump.
• Eliminate hazards caused by electrical energy (for
details refer to the country specific regulations and/or
local power supply companies).
• If there is no risk of the hazard potential being
increased by switching off the pump, provide an
emergency stop command device in the immediate
vicinity of the pump / pump unit when installing the
pump set.
1.7 Safety instructions for maintenance,
inspections and assembly
• Alterations or modifications of the system are only
permitted with the consent of the manufacturer.
• Use only original parts or parts authorised by the
manufacturer.
• Use of parts other than those authorised may lead to
loss of liability for any damage they may cause.
• The compact booster unit is assembled,
commissioned, maintained, and shut down solely by
sufficiently qualified and authorised personnel.
• The operator must ensure that the compact booster
unit is maintained and assembled by sufficiently
qualified and authorised personnel.
• Perform service on the system only when the machine
is off.
• The pump housing has to be at ambient temperature.
• The pump housing has to be depressurised and
empty.
• The procedures described in the manual for shutting
down the system have to be observed under all
circumstances.
• Reinstall safety equipment and protective devices and
activate them again immediately after work on the
system has been completed. Before starting up again,
observe the start-up checklist.
• Keep unauthorised persons (e.g. children) away from
the system.
• Wait at least 10 minutes before opening the compact
booster unit or before removing the power voltage
1.8 Unauthorised operation types
The limits that are stated in the documentation have to always
be complied with. The delivered system is only guaranteed to
operate reliably when it is used as intended.
MU1H-1382 GE23 R0521
GB
2

General information

2.1 Basic Principles
The manual is a part of the series and the versions as
mentioned on the title page. The manual describes the safe
and proper use in all modes of operation.
The manual describes the safe and proper use in all modes
of operation.
The type label indicates the series and size, the most
important operating data and the order number. The factory
number/serial number describes the identifies the system
uniquely and serves this purpose for all further business
transactions.
2.2 Installation of the incomplete
machine
For installation of incomplete machines, refer to the
respective chapter Maintenance.
2.3 Target group
Target group for the operating instructions is technical trained
personnel.
2.4 Other applicable documents
Documents
Supplier documentation
2.5 Safety instructions in this manual
DANGER!
Places with this sign signify that death, severe
bodily injury or significant property damage will
occur if the appropriate precautionary measures
are not followed!
WARNING!
Places with this sign signify that death, severe
bodily injury or significant property damage may
occur if the appropriate precautionary measures
are not followed!
CAUTION!
Places with this sign signify that small bodily injury
or slight property damage may occur if the
appropriate precautionary measures are not
followed!
DANGER!
General danger zone
In combination with a signal, this symbol indicates
danger of death or injury.
3
Contents
Operating manuals and
further documentation of
auxiliary equipment and
integrated machine parts