Troubleshooting - FS POE+ Serie Schnellstartanleitung

Quick Connect
Protocol:
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Show quick connect on startup
Step 4: Enter the default username and password, admin/admin.

Troubleshooting

Loading Failure Troubleshooting
After loading fails, the system will keep running in the original version. At this time, users should
re-check if physical port connections are good rstly. If some ports are not connected, then re-connect
them to ensure that physical connections are correct, and begin re-loading. If physical connections
are correct, then check the loading process information displayed on the super terminal to verify if
there are input errors. If there are input errors, correct them and re-load.
User Password Lost Troubleshooting
If the system password is lost or forgotten, the following method can be used to reset the password:
1. Connect the console port of the switch to the computer through the console cable.
2. Press ctrl + p to enter the Monitor# interface.
3. Delete the con guration le to achieve reset.
monitor#delete startup-con g
this le will be erased, are you sure?(y/n)y,
monitor#reboot
Do you want to reboot the Switch(y/n)?y
NOTE:
Forgetting your username and password and restoring them through console port
may cause con guration loss and business interruption. Please remember your username
and password.
10
Serial
Flow Control
COM3
DTR/DSR
115200
RTS/CTS
8
XON/XOFF
None
1
Save session
Open in a tab
Connect Cancel
x