Troubleshooting - FS S5800-48MBQ Schnellstartanleitung

Troubleshooting

Loading Failure Troubleshooting
After loading fails, the system will keep running in the original version. At this time, users should
re-check if physical port connections are good rstly. If some ports are not connected, then
re-connect them to ensure that physical connections are correct, and begin re-loading. If physical
connections are correct, then check the loading process information displayed on the super terminal
to verify if there are input errors. If there are input errors, correct them and re-load.
User Password Lost Troubleshooting
If system password is lost or forgotten, the following method can be used to reset the password:
1. Connect the console port of the switch to the computer through the console cable.
2. Press ctrl + b to enter the Uboot mode.
3. Start the system with an empty con guration le with no password.
Bootrom#boot_ ash_nopass
Bootrom#Do you want to revert to the default con g le?[Y|N|E]:
NOTE:
Forgetting your username and password and restoring them through console port
may cause con guration loss and business interruption. Please remember your username
and password.
Con guration System Troubleshooting
1. Make sure the power supply is normal and the console cable is properly connected.
2. Check if the console cable is the right type.
3. Check if the control cable driver is properly installed on the computer.
4. Ensure the parameters of the HyperTerminal are correct.
13