A-2.1.3 List Of Supported Pjl Commands - HP PSI PP 4050 XP Benutzerhandbuch

A-2.1.3 List of Supported PJL Commands
PJL COMMAND
@PJL COMMENT ["text"]
@PJL JOB [NAME= "text"]
[START= #] [END = #]
@PJL EOJ [NAME="job
name"]
@PJL ENTER LANGUAGE
= personality
@PJL RESET
@PJL INITIALIZE
@PJL DEFAULT
[LPARM : personality]
Variable = value
Description
The COMMENT command is used for adding a
line of information or a comment within a set of
PJL commands.
Defines the name and pages of a PCL print job.
NAME = file name (ASCII text)
START = first page, range 1 to 214783647
END = last page, range 1 to 214783647
The EOJ command marks the end of the job
which was started with the previous JOB
command. It resets the PJL Current
Environment to the User Default Environment.
The JOB and EOJ commands should always be
used in pairs. Do not use one without the other.
Supported personality options are
PCL , HEXDUMP
The RESET command resets the PJL Current
Environment variables to their User Default
Environment values (see Figure on page before
for a description of PJL Environments).
The INITIALIZE command resets the PJL
Current Environment and the User Default
Environment variables to their Factory Default
Environment values.
The DEFAULT command sets the User Default
Environment value for a specified variable.
Personality : PCL, HEXDUMP
For supported variables and values see table:
A-2.1.4 PJL Variables and Values
Appendix A Programming Guide
A-9