Parts And Description - JBL PROFLORA CO2 STARTER BIO SET Gebrauchsanweisung

Parts and description

UK
1
1. STARTER BIO reaction canister (1 x)
2. JBL PROFLORA CO₂ REFILL BIO, component A (1 x), component B (1 x)
3. CO
4. Suction cup (1 x)
5. Air stone (1 x)
6. Velcro tape (1 x)
2
1. ADVANCED BIO reaction canister (1 x)
2. JBL PROFLORA CO₂ REFILL BIO (1 x)
3. CO
4. Check valve JBL PROFLORA CO₂ SAFE STOP (1 x)
5. Diffuser JBL PROFLORA CO₂ GLASS MIDI (1 x)
6. Filter insert for reaction canister lid (1 x)
3
1. ADVANCED BIO reaction canister (1 x)
2. JBL PROFLORA CO₂ REFILL BIO (1 x)
3. CO
4. Check valve JBL PROFLORA CO₂ SAFE STOP (1 x)
5. Diffuser JBL PROFLORA CO₂ GLASS MIDI (1 x)
6. Thermal casing for reaction canister (1 x)
7. Filter insert for reaction canister lid (1 x)
8. Double-sided adhesive tape (1 x)
9. Screws for wall mounting (1 x)
Installation:
1. Unscrew the cap of the canister and fill component A and component B of the JBL PROFLORA CO₂
REFILL BIO into the reaction canister one after the other. Note: Never fill more than the contents of ONE
REFILL into the reaction canister! The second REFILL (Only
is intended only as a replenishment later!
2. Now fill the reaction canister with lukewarm tap water (approx. 20 –25 °C) up to the top marking (no
higher!!).
3. Screw the lid firmly back on to the reaction canister and shake briefly, holding the hose connection
opening closed with one finger. Note: There is an O-ring seal in the inner groove of the cover; make sure it
is seated correctly.
4. (
the protective foil from one side of the self-adhesive velcro tape (3) and apply it vertically below the lid of
the reaction canister.
5. (
reaction canister next to the aquarium and remove the second protective strip from the velcro tape. Now
press the canister with the self-adhesive side of the velcro tape against the aquarium. This will prevent
the canister from being knocked over accidentally and it can still be easily removed to be refilled when-
ever necessary. If there is no room next to the aquarium, the canister can reaction be attached in the
same way to any other vertical surface. However, it is important to ensure that the canister always stands
on a supporting surface. The velcro tape alone is not suitable for hanging the canister without additional
support!
6. (
double-sided adhesive tape and fix this to the left and right of the thermal casing's reverse side.
13 64610 00 0 V01-QuickGuide-BIO CO2-115x170.indd 8 13 64610 00 0 V01-QuickGuide-BIO CO2-115x170.indd 8
JBL PROFLORA CO STARTER BIO SET:
2
hose JBL PROFLORA CO₂ TUBE (3 m)
2
JBL PROFLORA CO BASIC BIO SET:
2
hose JBL PROFLORA CO₂ TUBE (3 m)
2
JBL PROFLORA CO ADVANCED BIO SET:
2
hose JBL PROFLORA CO₂ TUBE (3 m)
2
(Illustration on page 3 shows typical installation examples)
JBL PROFLORA CO STARTER BIO SET
2
JBL PROFLORA CO
STARTER BIO SET
2
JBL PROFLORA CO ADVANCED BIO SET
2
JBL PROFLORA CO
JBL PROFLORA CO BASIC BIO SET
and
2
JBL PROFLORA CO
BASIC BIO SET
and
2
only): Remove the protective strip from one side of the
ADVANCED BIO SET)
2
only): Remove
only): Place the
15.07.21 11:53 15.07.21 11:53