General Warnings; Parts Overview - Bresser National Geographic 70/400 Bedienungsanleitung

General Warnings

• Risk of blindness — Never use this device to look directly at the sun or in the direct proximity of the sun.
Doing so may result in a risk of blindness.
• Choking hazard — Children should only use the device under adult supervision. Keep packaging mate-
rial, like plastic bags and rubber bands, out of the reach of children, as these materials pose a choking
hazard.
• Risk of fire — Do not place the device, particularly the lenses, in direct sunlight. The concentration of light
could cause a fire.
• Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will con-
tact the Service Centre and can send the device in to be repaired, if necessary.
• Do not expose the device to high temperatures.
• The device is intended only for private use. Please heed the privacy of other people. Do not use this
device to look into apartments, for example.

Parts overview

1. Focus wheel
2. Eyepiece holder
3. Zenith mirror (diagonal)
4. Barlow Lens (3x)
5. Eyepieces (4 mm, 8 mm, 20 mm)
6. Smartphone adapter for use with the
ARTelescope App via Bluetooth
7. Battery compartment
8. Telescope tube
9. Objective lens
How to assemble the telescope
Before you get started with the assembly, you should take some time to decide where you would like to
set up your telescope. It is important that you choose a place from which you have an uninhibited view of
the sky, where the floor is hard and even, and where you have enough space around you so that you feel
comfortable. When you've found the ideal spot, you can begin the assembly.

Abb. 1
14
10. Tube opening
11. Dust protection cap
12. Fixation screw for the Telescope tube
13. Locating screw for the vertical axis
14. Vertical fine adjustment (for moving upward
15. Tripod legs
16. Tripod leg locking clip
17. Smartphone holder
18. Backpack
19. 1x CR2032 Battery
Open the locking clips on the tripod legs (16). Then pull the lower parts
of the tripod legs (15) downward as far as they will go. Finally, close
the locking clips again (Abb. 1). You can change the height of the tri-
pod at a later time by making the tripod legs a bit shorter (again, ope-
ning the locking clips, adjusting the legs, closing the clips).
(for turning to the right and left)
and downward)