Omnitronic CDV-500 Bedienungsanleitung Seite 25

9. CONTINUE/SINGLE-BUTTON
Choose single or continuous play.
„Single": After the current track is played, the player goes into pause-mode at the beginning of the next track.
„Continue" is the normal playback mode. After the current track is played, the player remains in playback-
mode.
10. CUE-BUTTON
In pause-mode, press the Cue-button to set a cue-point and store it to memory. The button flashes.
In playback-mode, press the Cue-button to return to the track start or the cue-point. The player goes into
pause-mode.
11. PLAY/PAUSE-BUTTON
Starts and stops playback of the CD and the platter. Each time PLAY is pressed after pausing, a new Cue
Point is set.
12. TRACK / FX-ENCODER
Select the desired track or set the effect parameters by rotating the knob.
13. SEARCH-BUTTONS
Press and hold one of these buttons to search the disc in the forward or reverse direction.
14. PROGRAM/ID-BUTTON
In pause-mode, you can load a Cue Memory-Point. In stop-mode, you can program up to 16 tracks per CD.
15. PITCH BEND-BUTTONS
Keep these buttons pressed to change playback-speed temporarily by ± 16 %. This way, you can
synchronize the bass beat of two signal sources. By releasing these buttons, the unit switches to the original
speed.
16. PITCHFADER
Adjust the desired speed. The display indicates the current pitch range and beats per minute (BPM). If the
pitch function is not active, the pitchfader has no function.
17. HEADSHELL
18. TONEARM
19. KEY LOCK-BUTTON
Activate the Key Lock-function to retain the original key even if the pitch playing speed is changed with the
pitch fader.
20. PITCH ON/OFF-BUTTON
Activates the pitch function.
21. PITCH SELECT-BUTTON
Select the speed-adjusting range between ± 8 %, 16 % and 50%.
22. TONEARM-CLAMP
23. COUNTERWEIGHT-SCALE
24. COUNTERWEIGHT
25. EFFECT-BUTTONS
Three effects that transform sound are selectable. Set the effect parameters with the encoder.
26. CENTER AXLE
27. PLATTER
25/40 10593010_V_1_0.DOC