Symbols Used In The Manual - Crown CT13394 Originalbetriebsanleitung

• Avoid stopping an electric tool motor when loaded�
• When sanding small workpieces too light for reliable
fixation, always use clamping appliances.
• Do not work materials containing asbestos� Asbes-
tos is considered carcinogenic�
• Should power supply fail during work, immediately
turn the tool's switch "Off" in order to avoid accidental
turning of the machine on�
• During the work (particularly when working above
the head level) use protective eyewear and dust mask
at all times� The dust created during the work irritates
the eyes and the respiratory system mucous mem-
branes whereas the dust inhalation may pose a severe
threat to one's health�
• The dust created during the work may be hazard-
ous to one's health, inflammable or explosive, hence
one should clean the work place at relevant times and
use personal protection means� Always use dust re-
moval / collection appliances (special vacuum cleaner,
dust bag)�
• When emptying the dust collection device, one
should maintain particular caution� Never dispose of
the dust in an open fire.
• When sanding some materials (paints with lead-
based pigments, wood impregnated with arsenic or
chromium compounds, etc�) carcinogenic or toxic
dusts may be produced� In such case, one should take
following precautions:
• all persons present on site should wear protective
clothes made of thick fabric and special anti-dust
masks (designed for protection against the hazard-
ous impact of a specific substance);
• the workplace should be well ventilated and dust
containers as well as dust removal devices (special
vacuum cleaners) must be used;
• cleaning of the workplace after work should be
performed by persons equipped with the aforesaid
personal protection means�
Warning: the chemical substances con-
tained in dust generated in sanding,
cutting, sawing, grinding, drilling and
other construction industry activities
may result in cancer, congenital deficiency or be
harmful to the fertility. The ion of some chemical sub-
stances shall be:
• Before any repair and replacement work to the ma-
chine, the power plug must be pulled out firstly.
• The transparent two silicon oxide and other ma-
sonry products in the wall bricks and cement; the
chromium arsenic (CCA) in wood with chemical treat-
ment� The harm degree of these substances shall
depend on the frequent degree of you carrying out
these works� If you want to reduce the contact with
these chemical substances, please work in the place
with ventilation and you shall use the appliances with
safety certificates (such as the dust mask designed
with tiny dust filter).
Notice the power voltage: in power connection, you
must confirm that if the power voltage is the same to
the voltage marked in the tool's data plate� If the power
voltage is higher than the appropriate voltage, the acci-
dents will be resulted to the operators, and at the same
time, the tool will be destroyed� Therefore, if the power
voltage has not been confirmed, then you shall never
plug in arbitrarily� On the contrary, when the power
voltage is lower than the required voltage, the motor
will be damaged�

Symbols used in the manual

Following symbols are used in the operation manual,
please remember their meanings� Correct interpreta-
tion of the symbols will allow correct and safe use of
the power tool�
Symbol
English
Autogoods "130"
20
Meaning
Rotary sander
Sections marked gray - soft
grip (with insulated surface)�
Serial number sticker:
CT ��� - model;
XX - date of manufacture;
XXXXXXX - serial number�
Hook-and-loop accessories
fastening�
Read all safety regulations
and instructions�
Wear safety goggles�
Wear ear protectors�
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�