Operation - Sharp SJ-PD591S Bedienungsanleitung

OPERATION

Control panel
Display for temperature setting
1.
The preset temperature of compartment selected is
displayed. It is not an actual temperature in the
compartment.
Display for compartment selected
2.
Select button
3.
The compartment selected can be changed by pressing
the select button.
Press the
select button
Initial display for
refrigerator compartment
/ button
4.
Use to select temperature.
button
5.
Finalizes the temperature setting.
6. Plasmacluster button and display
Press to start / cancel the plasmacluster operation.
NOTE
•
The display for temperature setting and selected
compartment will turn off when there is no operation for
1 minute. (When either of buttons is pressed, it lights
again.)
•
The plasmacluster display stays alight.
Plasmacluster
The plasmacluster automatically starts operating when the
refrigerator is powered on.
To cancel operation
Press the " " button (The light turns off).
To start operation
Press the " " button again.
Notes about PLASMACLUSTER operation
The ionizer inside your refrigerator releases clusters of
ions, which are collective masses of positive and
negative ions, into the freezer and refrigerator
compartments. These ion clusters inactivate airborne
mold fungus.
mold
fungus
• There may be a slight odors in the refrigerator. This is
the smell of ozone generated by the ionizer. The
amount of ozone is minimal, and quickly decomposes
in the refrigerator.
All manuals and user guides at all-guides.com
Controlling temperature
The refrigerator controls its temperature automatically.
However, if needed, adjust the temperature as follows.
Refrigerator compartment
Adjustable between 0°C and 6°C in steps of 1°C.
1
2
3
Initial display for
freezer compartment
Freezer compartment
Adjustable between -13°C and -21°C in steps of 1°C.
1
2
3
Door Alarm
When the refrigerator or freezer door is left open, the door
alarm will sound.
• The door alarm will sound 1 minute after opening the
• If the door is left open for approx. 3 minutes, the alarm
To cancel alarm signal
Press the select button continuously 3 seconds or more while
holding down the "
It is the same method also when restarting the alarm signal.
Press the select button.
lighting
Press the / button and set the temperature.
[ : increase, : decrease ]
Press the " " button.
Press the select button.
lighting
Press the / button and set the temperature.
[ : increase, : decrease ]
Press the " " button.
door and again after 1 minute (once in each case).
will sound continuously.
" button.
It shows the door alarm stop.
GB
E
I
F
P
GR
D
NL
PL
H
RO
CZ
SK
LT
LV
EST
SLO
UA
BG
5