Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Technical data
Rated voltage, extended range
Reference current I
(Limiting current I
ref
Internal consumption active power
Display
Accuracy class ±1%
Inrush current according to accuracy class B
Operating temperature
Interface
Terminal cover sealable
Protection degree
1)
Maximum conductor cross section
Recommended torque
2)
EC type examination certificate
The energy meter is used indoors.
Mechanical environmental conditions
Electromagnetic environmental conditions
1)
The carrying capacity of cables and wires is defined in DIN VDE 0298-4.
2)
The torques for screw terminals are mentioned in DIN EN 60999-1.
To avoid damages at the energy meter, the recommended torque values for each terminal must not be exceeded!
Must be kept for later use!
We recommend the housing for operating instructions GBA14.
Eltako GmbH
D-70736 Fellbach
Technical Support English:
+49 711 94350025
technical-support@eltako.de
eltako.com
03/2021 Subject to change without notice.
3x230/400 V, 50 Hz,
)
max
LC display 7 digits,
therefrom 1 digit after the decimal point
Pulse interface S0 according to DIN EN 62053-31,
potential free by opto-coupler,
max. 30 V DC/2O mA and min. 5 V DC,
impedance 100 ohms,
pulse length 30 ms, 10 Imp./kWh
Terminal cover claps
lP50 for mounting in distribution cabines
with protection class IP51
N and L terminals 16 mm2,
S0 terminals and jumper terminals 6 mm2
L- and N terminals 1,5 Nm (max. 2,0 Nm)
S0 terminals and jumper terminals 0,8 m (max. 1,2 Nm)
-2O%/+15%
3x0.05 - 5 (6) A
0.5 W per path
B
1O mA
-25/+55°C
0120/SGS0314
class M1
class E2
Werbung
