Installation And Operation; Safety Instructions; Installation And Connection - Gastrodomus GK413VSB Handbuch Zur Installation, Bedienung Und Wartung

5. Installation and operation

Safety instructions

WARNING! Electrical hazard!
Connect the device to a properly installed and grounded single power socket. Never yank
cord to disconnect from outlet. Cable must not touch any hot parts. Avoid water splashes
on the display refrigerator and do not expose the device to rain water, dripping water or
any other kind of moisture. The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that of the
device (see type label). Connect the device only in case of compliance! Take note of the
security advice!

See that the cable does not touch any heat sources or sharp edges. Do not let the cable
dangle over the counter edge.

Do not use the device in case it does not function properly, has been damaged or
dropped.

Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the device or
personal injury, and further, the warranty expires.

Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep away
the cable from operating range and do not dunk it into water.

Installation and connection

Installation and connection of the device should be performed only by a qualified specialist!
• Discard the complete packing material after unpacking the device.
• Place the device on top of an even and safe surface which supports the weight of the
device.
• Never at any time place the device on an flammable surface (such as: carpet, etc.).
• Do not place the device near the open fire sources, electric ovens, heating stoves or other
heat sources, for example direct sunlight. Exposition to high temperatures may cause
damage to the device surface or may negatively influence cooling power and energy
consumption.
• In order to avoid failures of the compressor when assembling or transporting the
refrigerated showcase, it should not be tilted over an angle of 45° at any time. Always use
doors with care as damages affect the optimal use.
• Set up the refrigerated showcase at an ample place, where a proper air circulation is
possible. A minimum distance of 5 cm must be kept to walls and other items.
• Do not set up the refrigerated showcase at places with high humidity or high
temperatures, as these effects may damage the device.
• On the first use the unit should be left to rest in a horizontal position at least 4 hours
before it is connected to the mains.
• Never punch holes into the refrigerated showcase. Never install foreign matters/
- 18 -