Transport Damage; Storage; Training Of Personnel; Troubleshooting, Fault Resolution - ABNOX AXDV-R1 Montageanleitung

EN

Transport damage

If transport damage is found during the receiving inspection, proceed as follows:
 Notify the carrier (shipper etc.)
 Record the damage
 Inform the supplier

Storage

Operation and interim storage in aggressive, damp environments or outdoors may
lead to corrosion and other damage. Maintain the storage temperature in the range of
–20 °C to +40 °C.

Training of personnel

Only trained and instructed personnel that has read and understood all points in the
operating manual is permitted to work on the product. The personnel must also be
able to control the operating states, and identify and implement the interrelated safety
aspects. Personnel in training may only work on the product under the supervision of
qualified personnel.

Troubleshooting, fault resolution

CAUTION
All of the faults described below may only be resolved by trained, qualified
personnel.
Fault
Air in the
system
Metering valve
leak at
discharge
Leakage from
tell-tale hole
(Fig. G/no. 12)
The motor turns
but no lubricant
is ejected
Indicator lamp
does not light
up green
44
Possible cause
Air pockets in the grease
container
Air pockets in the hoses
Air pockets in the valve
Worn stator
Input pressure too high
Defective shaft seal
The feed pump is not supplying
lubricant
The connection between the
motor and connecting shaft is
loose
Improper power supply
Corrective action
Loosen supply hose. Bleed
system. Reconnect supply
hose.
Replace stator (see
"Replacing the stator")
Reduce input pressure
Replace seal
Consult the operating
manual for the feed pump
Check the connection and
re-tighten the stud screw if
needed
Check power supply